Connecting The Power Cord(S) - NEC TM1200 User Manual

1. Unplug the AC power cord from the back of the chassis.
2. Insert the tip of a small screwdriver or ballpoint pen into the depression on the line voltage
selector.
3. Slide the selector switch to the left for 115 VAC or to the right for 230 VAC (line source
voltage range: 220 to 240 VAC).
A
B

Connecting the Power Cord(s)

Plug the female end of the AC power cord into the input receptacle on the rear of the
power supply cage. Plug the male end of the power cord into NEMA 5-15R outlet for
100-120 VAC or NEMA 6-15R outlet for 200-240 VAC.
If the power cord(s) supplied with the system is not compatible with the AC wall outlet
in your region, obtain a suitable power cord that meets the following criteria.
n
The power cord must be rated for the available AC voltage and have a current
rating that is at least 125% of the current rating of the system.
n
The power cord connector that plugs into the wall outlet must be terminated in a
grounding-type male plug designed for use in your region. It must have
certification marks showing certification by an agency acceptable in your region.
n
The power cord connector that plugs into the system must be an IEC- type CEE-
22 female connector.
n
The power cord must be less than 1.8 meters (6.0 feet) long.
230V
115V
Setting the Line Voltage
A - Voltage selector switch set to 230 VAC
B - Voltage selector switch set to 115 VAC
Setting Up the System 2-11