Daccf Configuration Utility - NEC TM1200 User Manual

Add-on Controller
If you are adding a RAID controller to an existing system, the AcceleRAID
Configuration Utility allows you to configure disk arrays and logical drives in your
system. Since the utility resides in the AcceleRAID
its operation is independent of the operating system in your server. Refer to Chapter 4
in this User's Guide for information on installing an add-in option board. Refer to
Chapter 4 of the AcceleRAID
AcceleRAID

DACCF Configuration Utility

The DACCF utility is included with the RAID controller. The AcceleRAID
support various versions of RAID technology (referred to as RAID levels). To use any
RAID level, you must configure the RAID controller using the DACCF Configuration
Utility prior to installing your Network Operating System. For an explanation of this
utility, refer to the Disk Array Controller Configuration Utilities Manual that was
shipped with the controller. Chapter 2 (Preparing the Array) covers array hardware
preparation, configuration, and initialization. After completing the steps in Chapter 2,
you can install your Network Operating System.
3-30 Configuring Your System
™
150 Installation Guide for information on running the
™
150 BIOS Configuration Utility.
™
150 BIOS on the RAID controller,
™
150 BIOS
™
150