Guide Rod - Inspire M1 Assembly & Operation Manual

STEP 28
Remove Bolts from Guide Rods
Step 28: Remove the bolts that connect the top of the Guide Rods to the Main Upright.
NOTE: Before beginning Step 29: If optional 200 lb. heavy weight stack is being assembled,
eliminate the weight stack risers. (This space will be taken up by 5 extra weight plates.)
Step 29: Slide Weight Stack Risers down the Guide Rods and onto the Shroud Plate. Next slide
the Rubber Donuts down the Guide Rods until sitting on Weight Stack Risers. Next slide
each plate down the Guide Rods until all 15 Weight Plates are resting on the Rubber
Donuts.
plate is signified by recessed area for weight plate number. Bottom of plate has three
feet). Next slide Top Weight/Selector Stem down guide rods and onto weight stack.
Finally connect top cable to top weight by threading cable bolt into Selector Stem.
IMPORTANT!! Cable bolt must be fully threaded into Selector Stem with Jam Nut
tightened securely before using. Failure to do so may cause the cable to come loose
from the weights and cause injury.
Be sure that all weight plates are facing forward and right side up. (Front of
IMPORTANT! Cable Bolt must be fully threaded
Into Selector Stem with Jam Nut tightened securely
Before using. Failure to do so may cause cable to
Come loose from weights and cause injury.
Shroud plate
Page 20
STEP 29
Install Weight Stack Risers,
Rubber Donuts, Weight Stack,
Top Weight/Selector Stem
(In That Order)
Front of weight plate has recessed
area for weight plate number
Bottom of weight plate has three
feet