Section 17: Attaching The Windshield, Side Windows, And Overhead Window - Hangar 9 Clipped-wing Taylorcraft Instruction Manual

Section 17: Attaching the Windshield,
Parts Needed
Fuselage
Windshield, side windows (7 pcs)
Wing skylight window (1 pc)
Step 1. Locate the windshield, side windows and overhead
window. Note the raised lines outlining the frames.
Step 2. Carefully trim the windshield and side windows,
making sure not to remove too much material. Trial fit the
overhead window to see if any trimming is needed. Periodically
check the fit of the windshield and side windows to the fuselage
while trimming.
Step 3. Trial fit the windshield and side windows to the fuselage.
46
Side Windows, and Overhead Window
Tools and Adhesives Needed
Phillips screwdriver
Scissors
Canopy Glue (Pacer Formula 560)
Masking tape
Small self-tapping screws (4)
Trim film/tape
Step 4. After confirming the fit of the windshield and side
windows, attach the side windows to the fuselage from the inside
using canopy glue. Use masking tape to hold the side windows
in place while the glue dries. Allow at least 24 hours to dry.
Step 5. Four small wood screws and canopy glue are used to
secure the front windshield to the fuselage, located on either side
of the fuselage, as shown below.