Hangar 9 Clipped-wing Taylorcraft Instruction Manual page 47

Section 17: Attaching the Windshield,
Step 6. After the windshield is firmly in place, apply trim film to
the frame outlines on the windshield for a more finished look.
Step 7. The cabin overhead window is held in place with
canopy glue and wood screws with washers. Trial fit the
overhead window to the opening in the wing center section. Mark
the location using a pencil or felt tipped pen. Also mark the
location the four screws will be positioned to hold the overhead
window in place.
Side Windows, and Overhead Window
Step 8. Use a 1/16" drill bit to drill holes in the clear overhead
window. Place the overhead window in position on the wing
center at the location previously marked in Step 7, and mark the
location of the screws onto the wing center section using a
pencil or felt-tipped pen.
Step 9. Attach the overhead window to the wing center section
using canopy glue and the four screws. Use masking tape to
hold in position until the glue cures (at least 24 hours).
CONTINUED
47