3.3.1.5 Add Bridge Configuration
In the WAN Service Setup page, click Add to add WAN configuration. This section
describes the procedure for adding br_0_0_32 (Bridge mode).
Step 1: Click Add to turn into the following page. (At first, you must add suitable ATM
configuration for this WAN configuration.) In this page, you can select ATM
Interface.
Step 2: Select an ATM Interface, such as atm1/(0_0_32). Click Next, and the following
page appears.
Step 3: In this page, you can modify the WAN service type, Service Description and
Enable IPv6 for this service. Click Next, and the following page appears.
54