Table of Contents
Advertisement
In this page, you can enter this PVC (VPI and VCI) value, and select DSL link type (EoA is
for PPPoE, IPoE, and Bridge.), encapsulation mode, service category, connection Mode.
VPI (Virtual Path Identifier): The virtual path between two points in an ATM network,
and its valid value is from 0 to 255.
VCI (Virtual Channel Identifier): The virtual channel between two points in an ATM
network, ranging from 32 to 65535 (1 to 31 are reserved for known protocols).
DSL Link Type: EoA (it is for PPPoE, IPoE, and Bridge), PPPoA, or IPoA
Encapsulation Mode: LLC/SNAP-BRIDGING, or VC/MUX
Service Category: UBR Without PCR, UBR With PCR, CBR, Non Realtime VBR,
Realtime VBR.
Connection Mode: Default mode, VLAN MUX mode, or MSC mode
Enable Quality Of Service: enable/disable.
In actual applications, you can modify them depending on your requirement.
You can also select the Enable Quality Of Service check box in to enable the packet
level QoS for a PVC. This improves performance for selected classes of applications.
Note: QoS cannot be set for CBR and Realtime VBR.
Click Apply/Save to save the configuration, and return the following page:
If you want to remove this Interface, please select the Remove check box and click
Remove.
40
Advertisement
Table of Contents
