User Manual of DS-8100HFI-ST Series DVR
5.1 Configuring Encoding Parameters
Before you start:
1.
Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
2.
Click Advance to check the storage mode of the HDD.
1)
If the HDD mode is Quota, please set the maximum record capacity and maximum picture
capacity. For detailed information, see Chapter 10.5 Configuring Quota Mode.
2)
If the HDD mode is Group, you should set the HDD group. For detailed information, see
Chapter 5.9 Configuring HDD Group for Recording and Capture.
Steps:
1.
Enter the Record settings interface to configure the encoding parameters:
Menu>Record>Encoding
Figure 5.1 HDD- General
Figure 5.2 HDD- Advanced
49