Table of Contents
Advertisement
User Manual of DS-8100HFI-ST Series DVR
3.
Check the SNMP checkbox to enable this feature.
4.
Configure the SNMP settings.
5.
Click the Apply button to save and exit the interface.
Note:
Before setting the SNMP, please download the SNMP software and manage to receive the device
information via SNMP port. By setting the Trap Address, the DVR is allowed to send the alarm event and
exception message to the surveillance center.
9.2.6 Configuring Remote Alarm Host
Purpose:
With a remote alarm host configured, the DVR will send the alarm event or exception message to the host when
an alarm is triggered. The remote alarm host must have the Network Video Surveillance software installed.
Steps:
1.
Enter the Network Settings interface.
Menu > Configuration > Network
2.
Select the More Settings tab to enter the More Settings interface, as shown in Figure 9.14.
Figure 9.13 Configure SNMP Settings
144
Advertisement
Table of Contents
