HIKVISION DS-8100HFI-ST Series User Manual page 16

User Manual of DS-8100HFI-ST Series DVR
6
EDIT/IRIS+
MAIN/SPOT/ZOOM-
F1/ LIGHT
F2/ AUX
MENU/WIPER
PREV/FOCUS-
PTZ l/IRIS
7
IR Receiver
JOG SHUTTLE
8
Control
ALARM
READY
STATUS
HDD
MODEM
TX/RX
9
GUARD
Note: If GUARD indicator is green (default), all alarm event and exception settings are valid. Otherwise, alarm
the Motion Detection and Privacy Mask menus.
The EDIT/IRIS+ button is used to edit text fields. When editing text
fields, it will also function as a Backspace button to delete the character in
front of the cursor. On checkbox fields, pressing the EDIT/IRIS+ button
will tick the checkbox. In PTZ Control mode, the EDIT/IRIS+ button
opens up the iris of the camera. In Playback mode, it can be used to
generate video clips for backup.
The MAIN/SPOT/ZOOM- button is used to switch between main and spot
output. In PTZ Control mode, it can be used to zoom out the image.
The F1/LIGHT button when used in a list field will select all items on the
list. In PTZ Control mode, it will turn on/off PTZ light.
The F2/AUX button is used to cycle through tab pages.
Pressing the MENU/WIPER button will return the user to the Main menu
(after successful login). Pressing and holding the button for 5 seconds will
turn off audible key beep. The MENU/WIPER button will also bring up
Sensitivity Interface settings. In PTZ Control mode, the MENU/WIPER
button will start wiper (if applicable).
The PREV/FOCUS- button is used to switch between single screen and
multi-screen mode. In PTZ Control mode, it is used to adjust the focus in
conjunction with the A/FOCUS+ button. It can also be used to select
entire masked areas, such as in Motion Detection and Privacy Mask
menus.
The PTZ/IRIS- button is used to enter the PTZ Control mode. When in the
PTZ Control mode, it is used to close the iris of the PTZ camera.
Receiver for IR remote
The JOG SHUTTLE control can be used to move the active selection in a
menu. It will move the selection up and down. In the Playback mode, the
ring is used to jump 30s forward/backward in video files. In Live View
mode, it can be used to cycle through different channels.
Alarm indicator turns red when a sensor alarm is detected.
Ready indicator is normally green, indicating that the DVR is functioning
properly.
Status indicator turns green when DVR is controlled by an IR remote.
Indicator turns red when controlled by a keyboard and purple when IR
remote and keyboard is used at the same time.
HDD indicator blinks red when data is being read from or written to
HDD.
Reserved for future usage.
TX/RX indictor blinks green when network connection is functioning
properly.
Guard indicator turns green when the device is in armed status; at this
time, an alarm is enabled when an event is detected. The indicator turnsoff
when the device is unarmed. The arm/disarm status can be changed by
pressing and holding on the ESC button for more than 3 seconds in live
view mode.
15