Table of Contents
Advertisement
LCD Alarm or Warning
wegener.com
Table 8: Alarm and Warning Descriptions
Message
Setting out of range
Test Mode in use
Unauthorized for CA
Unit overheating
Unread FP email
Using backup settings
Video Buff overflow
Video cmd muted
Video not found
Video PES data lost
Unity 4600 User's Manual
Meaning / Possible Cause
Current unit setting combination is illegal for installed
receiver card. Unit will be unable to acquire a carrier and
transport stream until corrected by the user.
One of the installation test modes is being used. This may
interfere with normal unit operation.
Unit unauthorized for Conditional Access in use. Contact
network provider. Also see "No KMS stream" & "KMS
stream lost" indications.
Unit overheating. Check that unit vents are not blocked and
that internal fan is connected and operating.
Unread Front-Panel email message present. Warning should
clear after user opens the screen containing the email.
Current permanent unit settings derived from successful
Auto-Recovery. User should review settings and restore to
primary if desired.
Video PES data buffer overflow. Video PES data is being
delivered faster than can be decompressed. There may be a
problem with the STC at uplink mux or in the IRD.
Video output muted by command from network or local
user.
Video PES data cannot be found at PID declared by PMT.
There may be an uplink mux or encoder failure.
Video PES data in selected program is unavailable. There
may be an uplink encoder failure.
77
800032-01 Rev. C
Advertisement
Table of Contents
