Wegener 4600 User's Reference Manual page 57

R type [page]
type: Indicates the type of report as follows:
[page]:This option can have a value of 1 to 40 and is only applicable for the
group status report. Indicates the page to be reported. If omitted, all eight pages
are reported and scrolls off the terminal screen.
With the R command, the user gets a combined report of unit non-volatile set-
tings and status and diagnostics for each item grouping (e.g. RF for all unit set-
tings and all status diagnostics for carrier acq/tracking). A Local Control
Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).
wegener.com
C - Carrier Status
P - Parameters
G - Group Status
GL - Genlock system (if installed and applicable)
M - MPEG PSI Status
NC - Network Controller Status
R - Relay Status
RTLOG - non-volatile log of last 10 "tuning" type commands
S - Settings Status
ST - Settings Table
SP - Serial Port Configuration
See also parameters for RP and RD commands.
Unity 4600 User's Manual
57 800032-01 Rev. C