Wegener 4600 User's Reference Manual page 55

Unity 4600 User's Manual
baud: 1200, 2400, 4800, 9600, 19200 or 38400.
parity: N, E, or O.
Configures communication parameters for any serial device. A Local Control
Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).
PERM [format] [pol/feed#] [carrier freq] [data rate] [FEC] [Tag Site] [pro-
gram#] [label]
format: If an RF input, one of the legal modulation formats: QPSK (for "DVB-
QPSK"), 8PSK (for "DVB 8PSK"), TQPSK (for "Turbo-QPSK"), T8PSK (for
Turbo-8PSK), T16QAM (for Turbo-16-QAM), or 16QAM (for "DVB
16QAM"). For an ASI Transport input, specify ASI. May be omitted if DVB-
QPSK. If this parameter is set to "OK", then the current setting, if a Transient
setting, becomes the new Permanent setting.
pol/feed#: If an RF input, one of four possible RF feeds, 1, 2, 3 or 4. If an ASI
input, one of two possible ASI feeds, 1 or 2. Omit this field for RF inputs if RF
switch option is not installed.
carrier freq: If an RF input, the downlink carrier frequency in MHz (precision
to two decimal places OK). Field is omitted for an ASI input only.
data rate: If an RF input, the Transport data rate in Mbps (precision to two
decimal places OK). Field is omitted for an ASI input only.
FEC: If an RF input, the inner FEC ratio. Field is omitted for an ASI input
only. The legal options are: for QPSK- 1/2, 2/3, ¾, 5/6, and 7/8; for 8PSK- 2/3,
5/6, 8/9; and for 16 QAM- ¾, and 7/8. Other legal values may be defined for
new modulation formats.
tag site: If an RF input, the tag site for Carrier ID tag. Field is omitted for an
ASI input only.
program#: Program number, '*' for wildcard, or null (for no program
assigned).
label: Channel Label (optional, may be omitted).
Command to establish new Permanent Unit Setting with the parameter values
given. If the format is set to OK, no other parameters are accepted or required.
wegener.com 55 800032-01 Rev. C