Wegener 4600 User's Reference Manual page 51

Unity 4600 User's Manual
IPCONFIG
Command requests report of all current IP parameters (IP address, Gateway
address, subnet mask) and assignment mode (static or DHCP). A Local Con-
trol Command (available from the terminal regardless of "Local Control
Enable/Disable" commands from the network).
LAN GATEWAY addr
addr:IP address formatted as n1:n2:n3:n4 where n1, n2, n3, and n4 are integers
between 0 and 255.
Command sets the IRD's static internet Gateway IP address. No protection is
offered against entry of non-standard addresses (e.g. 0:0:0:0). Omitting the
addr parameter shows the current static Gateway IP. This will not be the cur-
rent Gateway IP address if dynamically assigned. Use IPCONFIG command
for that. A Local Control Command (available from the terminal regardless of
"Local Control Enable/Disable" commands from the network).
LAN IP addr
addr:IP address formatted as n1:n2:n3:n4 where n1, n2, n3, and n4 are integers
between 0 and 255.
Command sets the IRD's static IP address. No protection is offered against
entry of non-standard addresses (e.g. 0:0:0:0). Omitting the addr parameter
shows the current static IP. This will not be the current IP address if dynami-
cally assigned. Use IPCONFIG command for that. A Local Control Command
(available from the terminal regardless of "Local Control Enable/Disable"
commands from the network).
LAN MODE mode
mode:"DHCP" or "STATIC".
Command sets the IP configuration to either dynamic DHCP or static IP
addresses. If static, see LAN IP, LAN GATEWAY, and LAN SUBNET com-
mands. Omitting the mode parameter shows the current mode. A Local Control
Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).
wegener.com 51 800032-01 Rev. C