Table of Contents
Advertisement
Unity 4600 User's Manual
MUTE [source][source][source] [...]
NOTE: The MUTE command is only allowed when local control is enabled
by the network.
source: If no source is specified then video and all audios are selected. Source
can be any of the following:
Mutes the specified outputs. Example: "MUTE V A1L A4 A3R" mutes the
video, audio Port 1 left channel, audio port 4 (both channels), and audio port 3
right channel.
OH
On hook. Disables modem access. Modem access is only re-enabled by suc-
cessful modem password entry. A Local Control Command (available from the
terminal regardless of "Local Control Enable/Disable" commands from the
network).
PARTPID pid
pid:Hex value between 20 and 1ffe to set a value and 0 to disable.
Command sets the borderline (or "partition") PID at, and above which, the
IRD may expect compatible scrambling against which it may apply the proper
descrambler. PIDs below this point may be scrambled with an alien, 3rd party
system. See individual IRD specs for more detail on unit behavior. A Local
Control Command (available from the terminal regardless of "Local Control
Enable/Disable" commands from the network).
PC device baud
device: one of MODEM, TERMINAL, AUXDATA, CA or COMPEL
800032-01 Rev. C
ASI - to indicate the DVB-ASI transport output.
V - to indicate Video.
A[specifier] -
To indicate Audio. An 'A' without the specifier
indicates all audio outputs. If present, The specifier
consists of one or two characters. The first character
specifies the audio port number and the second
character specifies either the right or left channel, as
in "A1L" (audio 1, left channel) or "A2R" (audio 2,
right channel). If the second character is omitted,
this indicates both stereo channels are included.
54
®
.
wegener.com
Advertisement
Table of Contents
