Table of Contents
Advertisement
LCD Alarm or Warning
Content Routing problem
E
Invalid COMPEL Hdr
wegener.com
Table 8: Alarm and Warning Descriptions
Message
Bad Video data
Bad Video PTS
Content for ASI N/A
/N
Margin warning
b
0
FP email fail
High Error Rate
High RF level
ID Tag Mismatch
ID Tags Lost
Invalid video format
KMS stream lost
Lost COMPEL PID
Unity 4600 User's Manual
Meaning / Possible Cause
Video PES stream appears to be invalid. Check if other
IRDs see similar problem on the same program.
Excessive jumps or jitter in video PTS values. There may be
a defective uplink encoder or mux.
Program content requested to route to ASI output cannot be
found in over-satellite transport mux. Contact network TOC
and advise.
ASI transport output bears no program content because a
Content Routing Table has not been loaded from the net-
work or is corrupt. Contact network TOC.
E
/N
value less than sum of Threshold + Margin—evalu-
b
0
ated over 10 sec. intervals. Unless the margin setting is
incorrect, this indicates a marginal downlink.
An FP Email message was received which was corrupt or
invalid. User should acknowledge the warning to clear, and
then notify the network TOC.
High errored seconds rate, presumably useless signal—
evaluated over 60 sec. intervals. Signal-to-noise ratio is
insufficient or there is severe terrestrial or antenna cross-pol
interference.
There is carrier lock, but the RF signal level is too high.
Carrier ID frequency text mismatch. User or network has
entered carrier frequency text or tag site ID incorrectly or
unit is on the wrong carrier.
Carrier ID tags disappeared. There may be a failure at the
uplink inserter (UMX5010) or loss of COMPEL PID. See
"ID Tag Mismatch" indication.
Invalid COMPEL header detected in incoming COMPEL
messages. This will cause the unit to immediately attempt
automatic recovery to a backup preset. The IRD is not set up
for connection to this COMPEL system.
Video format in requested program is not supported.
KMS stream lost after initially detected in this transport
stream. There could be an uplink problem. See also "No
KMS stream" indication.
Data traffic at designated packet ID (PID) for COMPEL has
been lost for more than two minutes. See "No COMPEL"
indication.
73
800032-01 Rev. C
Advertisement
Table of Contents
