Wegener 4600 User's Reference Manual page 52

Unity 4600 User's Manual
LAN SUBNET addr
addr:IP address formatted as n1:n2:n3:n4 where n1, n2, n3, and n4 are integers
between 0 and 255. Note that not all values can be legal.
Command sets the IRD's static subnet mask address. Command entries that do
not assert legal IP address masks will be rejected. Omitting the addr parameter
shows the current static subnet mask. This will not be the current subnet mask
if dynamically assigned. Use IPCONFIG command for that. A Local Control
Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).
LATCHALARMS x
x: Either 'E' for Enable, or 'D' for Disable.
Command enables or disables the latching of unit alarms.
LNBPWR output
output:Either ON or OFF.
Non-volatile command enables or disables LNB DC power independently of
any other settings. A Local Control Command (available from the terminal
regardless of "Local Control Enable/Disable" commands from the network).
LNBTST voltage_range tone
voltage_range:Either H or L (for High and Low).
tone:Either ON or OFF.
Volatile test command to force use of the ASTRA Universal LNB functions.
Disable with TESTOFF command. A Local Control Command (available from
the terminal regardless of "Local Control Enable/Disable" commands from the
network).
LOADNV source
source: "B", "C', or "P" for Backup (by user), Original Customer-configura-
tion, or Production-default settings, respectively. Key security parameters (e.g.
serial number) are not affected by the C or P loads.
Command reloads NVRAM memory from Flash memory defaults. Note that
unit must reset after execution of this command.
800032-01 Rev. C 52 wegener.com