Wegener 4600 User's Reference Manual page 59

Expanded U4600 report on unit NV operating parameters. A Local Control
Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).
RE state [number]
state: O or C meaning Open (ON) or Close (OFF), respectively.
[number]: 1 or 2 (or higher if relay option module installed) indicating the
affected user relay. Both are specified if omitted.
This command sets the user relay addressed by number to the ON/OFF state
specified. Command is non-volatile.
RESET
Resets unit. A Local Control Command (available from the terminal regardless
of "Local Control Enable/Disable" commands from the network).
RPATH
Command to display all return path non-volatile settings. A Local Control
Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network). A Local Control Command (available
from the terminal regardless of "Local Control Enable/Disable" commands
from the network).
wegener.com
MSC - Miscellaneous
PRGMP - Program mapping at ASI output
REC - Automated Recovery
RF - Carrier and RF
RPA - Return Path
S - Current Unit ("Perm") Settings
SER - Serial Ports
SW - Application software maintenance
TS - Transport Stream processing
VID - Video service
Unity 4600 User's Manual
59 800032-01 Rev. C