NAVE IIc
Nielsen Audio Video Encoder
Compressed
Welcome to your
NAVE IIc Nielsen Compressed Audio Video Encoder
Nielsen encoder expands upon Nielsen's audio-coding
WEGENER NAVE IIc
capabilities by supporting the ability to code a pre-compressed MPEG-2
transport stream. The
WEGENER NAVE IIc
MPEG-2 Multi-Program Transport Streams compliant with the US ATSC
standards. This
Quick Start Guide
operating your
NAVE IIc using the Web Interface
's abilities and detailed installation and operation instructions, please
NAVE IIc
consult the
NAVE IIc User's Reference Manual
worldwide web at www.wegener.com.
For additional help, contact us by phone at (770) 814-4057, by fax at
(678) 624-0294, or by email at service@wegener.com.
For questions about SID support, please contact the Nielsen Encoder Support
by phone at (800) 437-4872, or by email at AMOL@nielsenmedia.com.
1.
, ac power cord, and CD-ROM (Manual) from the
Remove the NAVE IIc
shipping carton. Call your shipping carrier immediately if any damage is
discovered.
2.
Remove the clear plastic covering
over the LCD window on the front panel.
www.wegwner.com
encoder will insert Nielsen data into
will help you quickly set up and start
. For a full description of the
available on CD or on the
from around the bottom of the unit and
Figure 1:
! The
3.
Place the NAVE IIc
mount it in a standard equipment rack. If rack-mounting your
please consult the
instructions and specific cautions.
4. C
onnect the following items:
The output from your DTV Encoder or Stream Splicer to the Receive
a.
input female BNC connector (A).
The output from the NAVE IIc, Transmit out female BNC connector (B),
b.
to your DTV transmitter or modulator.
Your LAN line to the NAVE IIc 's Network port (C), 10/100/1000baseT;
c.
female RJ-45 connector. See step 8 for Network port configuration.
Your time reference source, of your chose, to one of the following
d.
ports; NTP (C), SMPTE LTC (D) or GPS (E)
Connect the ac power cord to the NAVE IIc 's IEC receptacle (F) and
e.
to a 100-to-120-Vac or 200-to-240-Vac source. We strongly
recommend that you connect the NAVE IIc unit to an
power supply.
Rear-Panel Connectors
NAVE IIc
1
Quick Start Guide
indoors on a well-supported, flat table or desktop or
NAVE IIc User's Reference Manual
(Refer to Figure 1.)
,
NAVE IIc
for detailed
un-interruptible
800026-02 Rev. A