Table of Contents
Advertisement
vlan
lldp
show
2.3.2 Quick keys
Using the key...
Enter the "?" commands
Enter incomplete characters then
enter the question mark (?)
Press the direction
Enter unique part of a command and
press TAB key
2.3.3 General Commands
This section introduces you some general commands that you can use in User, Enable, and
Config mode, including "help", "exit", "history", "logout", and "show".
Entering the command...
Enter the "help" command
Enter the "exit" command
Enter the "history" command
Enter the "logout" command
Enter the "show" command
SIGNAMAX a.s.
Office: Vlarska 22, 627 00 Brno, CZ
T:+420 533 338 854 l F:+420 533 338 883 l www.signamax.eu
When in Config
mode, enter the
vlan command.
When in Config
mode, enter the
lldp command.
When in Config
mode, enter the
show command or
enter the show
command and
followed by the
command you
would like to
view its current
setting.
To do this...
Obtain a list of available commands in the current
mode.
List all commands similar to incomplete characters.
or
key
Scroll through the command history.
The switch will automatically display the full
command.
To do this...
Obtain a list of available commands in the current
mode.
Return to the former mode or login screen.
List history commands that have been entered.
Logout from the CLI. ("logout" can not be used in
the Config mode.)
Show system information.
Show available commands.
Show a command's current settings.
Show currently-configured settings.
SWH (config-vlan)# Set up VLAN mode
SWH (config-lldp)#
SWH (config)#
16
and VLAN
configuration.
Set up Link Layer
Discovery Protocol
(LLDP) configurations.
Show a list of
commands or show the
current setting of each
listed command.
Advertisement
Table of Contents
