Cordless Headset - AT&T Syn248 SB35031 User Manual

Syn248 SB35031 Deskset User's Guide

Cordless Headset

The headset is not responding.
Probable Cause
The headset has lost
connection to the Deskset.
The headset is not
registered.
The headset does not work at all.
Probable Cause
The headset is not getting
power from its battery.
Troubleshooting
Corrective Action
1. Disconnect the cordless headset battery.
2. Wait three minutes.
3. Install the battery again and place the cordless
headset into the charger.
4. Wait for the ON/OFF light on the headset to
display a blue light, indicating that the headset
was able to reestablish its connection with the
Deskset. Allow up to one minute for this to take
place.
1. Remove and replace the headset from its charger
base.
2. Register the headset at the Deskset. See
"Registering an Optional Cordless Headset" on
page 92.
Corrective Action
Verify that the battery is installed and charged

correctly.
Place the headset into the accessory charger.

Ensure the charger is securely plugged into an
outlet not controlled by a wall switch. The
headset LED will light to indicate that the headset
is charging.
If the battery is completely depleted, it can take

up to 10 minutes to charge the battery enough
for the headset to work even briefly. In this case,
the ON/OFF LED will remain off and you will not
be able to use the device. After 10 minutes of
charging, remove the headset from the charger
and press ON/OFF on the headset or
(HEADSET) on the Deskset to turn on the
headset.
Replace the headset battery.

124
Back to Contents