AT&T Syn248 Quick Start Manual

®
Syn248 System Installation

Quick Start Guide

For complete installation information,
see the Syn248 Installation and Configuration Guide,
available at smbtelephones.att.com/product-support.
1
System Components and Tools Required
• SB35010 Gateway You can install up to two Gateways to support
up to eight telephone lines.
• SB35020/SB35025/SB35031 Desksets The system supports up
to 24 Desksets. The SB35025 Deskset supports Music on Hold and
overhead paging connections, and an AT&T DECT Cordless Headset.
The SB35031 Deskset supports an AT&T DECT Cordless Headset.
• CAT 5 LAN cables One per Deskset/Gateway is included.
• Power adapters for Gateways and Desksets (included). If your Local
Area Network (LAN) switch supports Power over Ethernet (PoE),
you can power the Desksets through the switch instead of using
adapters. Check your LAN switch specifications.
• LAN switch If using PoE to power Desksets, the switch ports must
provide PoE Class 2.
• Audio cables The audio in/out cable included with the SB35025
Deskset enables you to connect a Music on Hold source and an
overhead paging system. Additional audio cables are also required.
• An Internet connection is recommended to provide accurate system
time and enable software updates.
• Screwdrivers/hardware for wall-mounting/rack-mounting Syn248
devices. Gateway rack-mounting brackets and screws are included.
System Diagram
Blue lines: Telephone
Red lines: Ethernet/CAT 5
Orange lines: Audio
Dotted lines: DECT wireless
2
Install the Gateway
You can place the Gateway on a tabletop, mount it into a standard 19-
inch metal rack, or wall mount it.
Rack-mounting
19 in. (48.3 cm)
3
Connect the Telephone Lines to the Gateway
Do not connect power to the Gateway yet.
If your phone company provides you with Centrex service, see the
Syn248 Installation and Configuration Guide before proceeding.
Connect telephone lines to the Gateway LINE ports using the supplied
cables. Ensure that the lines are configured as you ordered them from
Wall-mounting
your service provider, and that you have decided which lines will be
LINE 1, LINE 2, and so on for your Syn248 system.
If you subscribe to Digital Subscriber Line (DSL)
high-speed Internet service through your telephone
line, plug a DSL filter between each telephone line
with DSL service and the telephone wall jack.
7 7/8 in. Optional: Connect an analog phone to the BYPASS port for use during
(20 cm)
a power outage. During a power outage, calls on the line connected to
Gateway LINE 4 are routed to the BYPASS port.