TABLE 12
Parameter
Parity
Stop bits
Data bits
If you need to connect to the SER MGT port using either a DB-9 or a DB-25
connector, use an adapter to perform the cross-overs. See the Sun System Handbook
for more information about the cross-overs.
USB 2.0 Ports
Both servers have two USB 2.0 ports (0 and 1) on the rear panel. Use ports 0 and 1 to
connect input devices such as a keyboard and mouse. The USB ports support hot-
plugging. You can connect and disconnect USB cables and peripheral devices while
the system is running without affecting system operations.
You can perform USB hot-plug operations only while the Solaris OS is running. You
must run the devfsadm -C command after a USB hot-plug operation. USB hot-plug
operations are not supported when the OpenBoot PROM prompt is displayed or
before the system has completed booting.
PCI Expansion
Both servers use a variety of riser cards to provide different combinations of PCI-E
and PCI-X expansion slots.
For a detailed list of expansion options, go to:
http://www.sun.com/servers/
16
Sun Fire V215 and V245 Servers Getting Started Guide • September 2006
Default Serial Connection Settings
Setting
None
1
8