Speco D12LX Operation Instruction Manual page 67

Highlight Device Register and press the
screen appears. Setting up the Authentication is required to register the network device to the DVR.
Proper registration and authentication settings will display registered devices in the list of the Network Camera setup screen.
Highlighting the box under the Settings heading and pressing the
NOTE: The Settings screen will differ depending on the type of protocol that you selected. The following
description is for a network device using the ONVIF
Highlighting the box beside Stream Protocol and pressing the
Highlighting the box beside Record Protocol and pressing the
Highlighting the box beside ONVIF Profile and pressing the
Highlighting the Port Number Setup... box and pressing the
number and the RTSP server's port number.
Highlight Authentication and press the
information is required to change the device settings.
Highlight Use Audio Recording and press the
record audio from the device when video from the network device is recording.
Highlight the Device Remote Setup box and press the
Appendix – Remote Setup of Network Devices for details.
button to register the selected network device(s) from the list. An Authentication
Highlight the box beside User/Password and press the
keyboard appears allowing you to enter the user ID and password. Highlight
Apply to All Devices and press the
information to all the network devices in the list. When selecting multiple network
devices in the list, selecting Skip skips the authentication settings for the current
network device and displays the Authentication screen of the next network device.
TM
Highlight Enable and press the
it is On, you will be able to change the device settings.
Highlight the box beside Name and press the
appears allowing you to edit the device name.
You can assign IDs to each camera by highlighting the box beside Camera ID
and pressing the button. Change the number by highlighting it and using
the Up and Down arrow buttons to increase and decrease the number. (4-ch
Network Video Transmitter Only)
Highlighting the box beside Address and pressing the
to change the IP address of the device.
Highlight the box beside User/Password and press the
keyboard appears allowing you to enter the user ID and password used when
changing device settings.
button allows you to select the protocol for recording.
button allows you to select a preset ONVIF
button. An Authentication screen appears, and entering Authentication
button to toggle between On and Off. When it is On, the DVR will
button. The Device Remote Setup screen appears. See
button to apply the same authentication
button allows you to change the device settings.
Conformance protocol.
button to toggle between On and Off. When
button. A virtual keyboard
button allows you to select the protocol for streaming.
button allows you to select the HTTP server's port
Digital Video Recorder
button. A virtual
button allows you
button. A virtual
TM
profile.
59