Storage; Camera Setup; General; Figure 40 : Status - Storage Setup Screen - Speco D12LX Operation Instruction Manual

Disk Added/Removed will be highlighted when the hard disk drive is connected or disconnected while the DVR is
operating.
No storage found will be highlighted when there is no storage device for recording is installed in the DVR when the
DVR boots for the first time.
Disk Config Change will be highlighted when the DVR reboots after the hard disk drive has been replaced.

Storage

Highlight Storage and press the
The Type column displays the type of storage device.
The Disk Bad column displays the percentage of bad sectors. Not formatted indicates the device is not formatted.
The Temperature column displays the temperature of the storage device.
The S.M.A.R.T. column displays "Good", "Bad" or "N/A", depending on storage conditions.
 Good – The storage condition is normal.
 Bad – Data cannot be written on or read from the storage device.
 N/A – Storage conditions are normal, however, the S.M.A.R.T. monitoring is not working or supported.
NOTE: When the storage condition is "Bad", the Event Status – Storage screen displays and you can check
the storage condition for details. Once the "Bad" message displays, replacing the hard disk drive is
recommended, usually within 24 hours.
Temperature and S.M.A.R.T. information will be available only for internal hard disk drives supporting
the SMART (Self-Monitoring Analysis and Reporting Technology) monitoring program.
The box beside Recorded Data – From / To displays the time information of recorded data.

Camera Setup

General

Highlight General and press the
button, and the Storage setup screen appears.
Figure 40 : Status – Storage setup screen.
button, and the General setup screen appears. (Local Cameras Only)
Digital Video Recorder
55