Speco D12LX Operation Instruction Manual page 66

Operation Instruction
Highlighting the box beside Protocol and pressing the
device you want to search.
NOTE: Refer to the network device manufacturer's instructions about enabling the ONVIF
in the device, as procedures may differ for each model.
Highlight the box beside Mode, and press the
IP Address Scan and Domain Name Scan. Select the desired mode and press the
NOTE: The supported scan modes differ depending on the protocol you selected.
If the IP address range of the device is different from that of the DVR, the DVR considers the IP address
invalid. In this case, you must change the device's IP address to register the device.
Selecting Auto Scan (LAN) from Mode scans network devices automatically.
Selecting IP Address Scan from Mode scans network devices by entering a specific IP address or adjusting the IP
address range. Highlighting Port and pressing the
NOTE: Using the IP Address Scan, you can search for a network device that cannot be searched for using the
Auto Scan (LAN) mode.
Selecting Domain Name Scan from Mode scans network devices by entering the domain name of the network device.
Highlighting Port and pressing the
NOTE: For the Domain Name Scan feature to work, the DNS sever should be configured during Network – IP
Address setup.
After selecting the desired scan mode, highlighting Search and pressing the
devices and displays them in the list. Selecting Reset allows you to delete the search results list.
NOTE: Depending on the model of network device, the device may not be supported even though the DVR supports
the device's protocol. Ask your dealer or distributor about supported device models.
58
button allows you to select the protocol for the network
button. You can select the scan mode between Auto Scan (LAN),
button allows you to set the port number used for remote monitoring.
button allows you to set the port number used for remote monitoring.
TM
Conformance protocol
button.
button, the system searches for network