Chapter 3 - Configuration; Front Panel Controls; Power Led; Hdd Led - Speco D12LX Operation Instruction Manual

Chapter 3 — Configuration
NOTE: Your DVR should be completely installed before proceeding. Refer to Chapter 2 — Installation.

Front Panel Controls

Power LED

Copy Button
Sequence Button
Enter Button
The front panel looks and operates much like a VCR combined with a multiplexer. The following describes each button
and control. Take a few minutes to review the descriptions. You will use these to initially set up your DVR and for
daily operations.
NOTE: The infrared sensor on the DVR is just to the left of the Jog Dial. Make certain that nothing blocks the
sensor, or the remote control will not function properly.
When you use wireless communication devices (such as Wi-Fi or Bluetooth) near the DVR, the remote
control might not function properly.
You can also use a USB mouse (not supplied) to navigate through the screens and menus much like you
would on a computer.
Power LED
The POWER LED is lit when the unit is On.

HDD LED

The HDD LED flickers when the DVR is recording or searching video on the hard disk drive.

Camera Buttons

Pressing the individual camera buttons will cause the selected camera to display full screen. Pressing the buttons 1 to
4 toggles the camera selection between local cameras and network cameras. For example, pressing the button 1 displays
the local camera number 1 and pressing the button 1 again displays the network camera number 1. Buttons are also
used to enter passwords.
NOTE: When selecting the camera channel from 10 to 16, press the 10+ and then 0 to 6.

Figure 3 : 16-Channel DVR front panel.

HDD LED Camera Buttons
Esc Button Play/Stop Button
PTZ Button Mode Button
Jog Dial Shuttle Ring
Digital Video Recorder
Menu Button
Alarm Button
Arrow Buttons
USB Port
7