Cooper Security i-on160EX Administrator's And User Manual page 73

i-on160
Hint: When you are programming calendar set options it is easier
to set up your exceptions first, and then add the events. Also,
make sure that you have set the system time and date accurately
(see page 64).
Calendar Set Options
To program Calendar Sets use the System Config – Calendar Sets
option within the Menu. Note that you must be an Admin or
Master User to program Calendar Sets. When you enter the
Calendar Set option press u or n to see the following options:
Add Event
Use this option to create an event. When you select the option
the control unit will guide you through the following series of
steps to ensure that you add all the required information:
Event Name. Key in a 12 character name (or press Y to leave
the default name).
Event Time. Use the 24 hour clock. Note that if you specify a
start time that is less than 10 minutes from the current time
shown by the control unit clock then the event will not take
action until the following start day.
Event Days. Press u or n to scroll through each day of the
week. Press < or > to specify Yes (event occurs on that day)
or No.
Event Actions. In a part setting press < or > to select one of:
Full Set, Part Set B (or C or D) and Unset.
In a partitioned system the keypad display shows a list of
partitions. Press u or n to scroll through each partition. Press
< or > to select one of the actions: Full Set, Part Set or
Unset. Alternatively, select "No" if you do not want the
partition involved in the event. Remember that one event in a
partitioned system can affect more than one partition.
Event Exceptions. Press u or n to scroll through the list of
programmed exceptions. Press < or > to specify "Yes" (the
exception applies to the event) or "No" (the exception does not
apply to the event).
4. Administration
Page 67