To Remove/Install A Saw Blade - Chicago Electric 90891 Set Up And Operating Instructions Manual

FIgURE F
1/4" MOUNTINg HOLE
3. Use two C-clamps (not included) to secure the back side of the Miter Saw to the
table/workbench.

To Remove/Install A Saw Blade:

WARNINg! Prior to performing this procedure, make sure the Miter Saw is un-
plugged from its electrical outlet.
When replacing a Saw Blade (51), make sure the new Saw Blade has a 10"
diameter, rated to at least 4600 RPM, made to fit a 5/8" (0.625") Spindle, and
suited for the type of material being cut.
SAW BLADE (51)
FIgURE g
1. Lift up and hold the transparent Safety Cover (58) in place. (See Figure g.)
SKU 90891 For technical questions, please call 1-800-444-3353.
1/4" MOUNTINg HOLE
FRONT COVER
WITH SUPPORT
LEg (117)
SAFETY COVER (58)
Page 12