To Adjust The Bevel Angle; To Adjust The Support Screw - Chicago Electric 90891 Set Up And Operating Instructions Manual

To Adjust The Bevel Angle:

WARNING! Prior to performing this procedure, make sure the
Power Cord of the Miter Saw is unplugged from its elec-
trical outlet.
FIgURE O
SCALE PLATE
(89)
1. The bevel angle (or Saw Blade tilt capacity) may be adjusted
from 0 - 45 degrees to the left. To do so, loosen the Lock Handle (59) located at
the rear of the Miter Saw. (See Figure O.)
2. Tilt the Arm Holder (82) until the desired compound angle of cut is achieved as
indicated on the Scale Plate (89). Then, retighten the Lock Handle (59) to lock
the Arm Holder in place. (See Figure O.)

To Adjust The Support Screw:

1. The Support Screw (138) can be adjusted by turning it clockwise to lengthen it or
by turning it counterclockwise to shorten it.
2. It should be adjusted so that it rests just above the surface of the table or bench
the saw is mounted on.
SKU 90891 For technical questions, please call 1-800-444-3353.
SUPPORT SCREW
(138)
To Adjust The Support Screw:
1. The Support Screw (138) ca
adjusted by turning it clockw
lengthen it or by turning it co
clockwise to shorten it.
2. It should be adjusted so tha
just above the surface of the
bench the saw is mounted o
ARM HOLDER
(82)
LOCK HANDLE
(59)
Page 19