Table of Contents
Advertisement
2.
Plug the Charger Base into a wall socket. Note: The Charger Base has an ON red
light, an OFF green light, and a SET button.
3.
When the Charger Base is plugged into a wall socket, the GREEN light will go on.
This shows that all circuitry is working properly and the Charger Base is ready to
charge.
4.
Press the SET button to start the charge. The red light will go on and will continue to
be on while the Battery is charging. The Battery will charge in approximately 1-1/2
hours. When the RED light goes off, the Battery charge is complete.
5.
After charging, unplug the Charger Base from the wall socket.
6.
Remove the Battery from the Charger Base and insert the Battery into the base of the
tool.
Note: The operation time of a new battery will ramp up as it is properly used and recharged.
It will take about 5 cycles before the battery is at maximum efficiency.
Warning: If two or more batteries are to be charged, allow the Charging Base time to cool
down between charges.
Warning: Never charge more than 2 hours continuously. Chargers should not be left
plugged in or charging for more than 2 hours.
Remove battery before making any adjustments. Install saw blade. Prepare and secure the
material to be cut before turning on saw. Battery should have a full charge before using saw.
Refer to illustrations that follow.
1.
Remove battery.
2.
Press on the stop button (#17) located on top of the saw to keep the saw blade from
moving while turning the nut bolt.
3.
Using the hex key (#48), loosen and remove nut bolt (#1) and washer (#2).
4.
Rotate movable guard (#8) clockwise to allow entry of blade.
5.
Insert saw blade through the base with teeth facing forward (and up) until the center
holes of the saw blade and motor adapter (#5) align. (Notice the arrow on the movable
guard and the arrow on the saw blade, they should be pointing in the same direction.)
6.
Replace washer (#2) and nut bolt (#1). Tighten with hex key (#48) while pressing on
the stop button (#17). Verify stop button is in the up (unlocked) position.
7.
Replace key to its storage hole in the housing of the saw.
SKU 37412
Operation
Installing Saw Blade
Page 5
07g
Rev 09/98, 05/02
Hide quick links:
Advertisement
Table of Contents
