Chapter 8 Firmware Upgrade - Comtrend Corporation CT-535 User Manual

Wireless adsl router

Hide thumbs Also See for CT-535:

Table of Contents

Chapter 8

Follow the steps below to upgrade the firmware version of the wireless router via the

FTP:

STEP 1: Connect the Router to a PC using the LAN cable. Set the PC to the same

subnet as the router (192.168.1.x/24).

STEP 2: Restore the default parameters of the wireless router by holding down the

device's Reset button until the WLAN LED starts blinking (about 5

seconds). After the device has rebooted successfully, and if the ADSL

connection is established, the WLAN LED will stop blinking and the ADSL

LED will display in green. If an error occurred, the ALARM LED will start

blinking in red.

Note:

You can also reboot the wireless router by running the device software and

selecting the ERASE command on the Erase and Reboot menu.

STEP 3: Start DOS and enter the menu where the new firmware is installed:

Example: C:\Upgrade

STEP 4: Enter the command: ftp 192.168.1.1 (router's IP address)

STEP 5: At the User prompt type root

STEP 6: At the Password prompt type 12345

STEP 7: After you see the message User logged in, type: bin

Firmware Upgrade

Table of Contents