Table of Contents
Advertisement
Firewall Parameters
Existing Action ID: If an action has already been established, check the box next
to Existing Action ID and enter its Action ID.
New Action: If a new action is required check the box next to New Action and
then enter: Interface Name –the interface the action applies to, FW Action: Enter
Allow, to enable packets to pass through the router, Deny to drop corresponding
packets, Reject to reject packet with a response, e.g., sending a TCP reset, or
Reset to reject a packet with a reset flag.
Direction – the direction can be IN – only packets received are affected. OUT –only
packets sent are affected or ANY –both packets sent and received are affected.
57
Advertisement
Table of Contents
