Adjusting The Blower Speed; Normal Operating Sounds - Travis Industries DVL Insert Owner's Manual

Adjusting the Blower Speed

The internal blower helps transfer
the heat from the heater into the
room. It will not turn on until the
heater is up to temperature
(approximately 10 minutes after
starting). See the illustration below
for instructions on adjusting the
blower speed.

Normal Operating Sounds

Pilot Flame
The pilot flame,
which remains on,
makes a very slight
"whisper" sound.
Gas Control Valve
As the gas control valve is turned on
and off you will hear a dull clicking
sound. This is the valve opening up
and shutting down.
Travis Industries
Operation
OFF
HI
LO
BLOWER
CONTROL
4 0 1 1 0 2 5
Blower Knob
Turn the knob all the way counter-clockwise to turn
the blower off. One click clockwise turns the
blower to high speed. Turning the knob clockwise
from the high position decreases the speed of the
blower.
Blower
This heater uses a blower to push
heated air into the room. You will hear
the sound of air movement that
increases as the speed is increased.
The appliance will
creak with change of
temperature.
Blower Snap Disk
This part can
produce a clicking
sound as it turns the
blower on and off.
2 3
9 3 5 0 8 1 0 4