Manifold Removal And Installation - Travis Industries DVL Insert Owner's Manual

Installation
1 4

Manifold Removal and Installation

• The manifold is shipped attached to the insert, but may be removed to facilitate especially tight
installations. See the directions below for installation.
1 Remove the manifold and place it within the fireplace (see the instructions on the following page).
2 Route the flex vent through the chimney from above (leave an extra 3' (914 mm) at the top).
3 Attach the flex vent to the manifold (seal with silicone and attach with screws).
4 Place the manifold in an upright position (so it rests on the manifold legs) and have a partner pull on
the excess flex vent. Temporarily attach the flex vent to the top of the chimney (leave extra slack).
5 Slide the insert into place, guiding the convection top over the insert until fully in place.
6 After removing any slack from the flex vent, attach the manifold to the appliance.
7 Remove any excess slack in the flex line then attach the vent termination.
2
1
Travis Industries
(for qualified installers only)
3
4 0 1 1 0 2 5
4
5
4
7
6
9 3 5 0 8 1 0 4