Thermostat - Travis Industries DVL Insert Owner's Manual

3 4
Thermostat (Part # 99300650)
! Do not connect 120 VAC to the gas control valve or wiring of this unit.
+ It is easiest to route the remote control wire prior to installing the appliance. Route the wire to a
location near the gas inlet. Allow 3' of wire for hookup inside the heater.
1 Attach the thermostat wire and route through the gas inlet hole (see the illustration below).
through all the slack (you may wish to wrap the wire in electrical tape to prevent damaging the wire).
2 Determine a location for the thermostat that is within range of the 50' length of thermostat wire. It
should be centralized in the room and away from the heater. The wire may be routed externally on the
wall or behind the wall (preferred).
3 Cut the thermostat wire so there is approximately 6" of slack (NOTE: Do not splice thermostat wires
together–this leads to too much electrical resistance). Expose 1/2" off each wire of the thermostat
wire. Attach the exposed wire to the clips on the back of the thermostat using a screwdriver.
4 Pull the cover off the thermostat. Place the thermostat in location and attach it to the wall through the
two obround holes (use the appropriate screws for the type of wall it is being attached to). Replace
the cover on the thermostat to complete the installation.
Travis Industries
Optional Equipment
Side of
Fireplace
Green
Jumper
b
Route the wire through
Faceplate
the gas inlet hole
Expose 1/2" of
wire and attach
to the two
connections on
the back of the
thermostat (use a
screwdriver).
Orientation does
not matter.
Back Side of

Thermostat

Pull the cover off the
thermostat to expose the
holes for mounting the
thermostat.
Wire
4 1
Wire
5 2
Back of on/off switch
a
Remove and discard the jumper wire on the back of the
on/off switch. Attach the quick connects on the end of the
wire to the two posts the jumper wire was attached to.
Wall
Use the appropriate screws to
mount the thermostat to the wall.
4 0 1 1 0 2 5
Pull
PILOT
ON IGNITER
OFF
Run the thermostat
wire through the
wall (cut off
excess wire,
leaving 6" of slack)
9 3 5 0 8 1 0 4