Table of Contents
Advertisement
Installation
(for qualified installers only>
15
Manifold Removal and Installation
•
The manifold is shipped attached
to
the insert, but may be removed to facilitate especially tight
installations.
See the directions below for installation
.
1
Remove the manifold and place it within the fireplace (see the instructions on the following page)
.
2
Route the flex vent through the chimney
from
above (leave an extra 3' (914 mm) at the top).
3
Attach the flex vent to the manifold (seal with silicone and attach with screws)
.
4
Place the manifold in an upright position (so it rests on the manifold legs) and have a partner pull on
the excess flex vent. Temporarily attach the flex
vent to the
top of the chimney (leave extra slack)
.
5
Slide the insert into place
,
guiding the convection
top
over the insert until fully in
place.
6
After removing any slack from the flex vent, attach
the
manifold to the appliance.
7
Remove any excess slack in the flex line then attach the vent
termination.
m
. .
·.·,.·
....
·
. .
·.·
. .
·. ·:':
.·
. .
·
©
Travis Industries
4041213
100-01150
Advertisement
Table of Contents
