Post Inserter; Keys On Control Panel - Konica Minolta Bizhub 652 User Manual

5
Settings
[Position Setting]
5.1.6

Post Inserter

When the Post Inserter PI-505 is installed on the Finisher FS-526, you can manually operate the Finisher
FS-526 using the post inserter control panel.
Reference
- Only the lower tray can be used as the output tray. The upper tray is not available.

Keys on control panel

No. Name
1
Corner Staple Lamp
2
Center Staple & Fold Lamp
3 [Finishing]
4 2-Hole Lamp
5 3-Hole Lamp
6 [Select punch]
7 [Start/stop]
8 4-Hole Lamp
9 Tri-Fold Lamp
10
2 position staple lamp
5-14
Configure desired staple or hole-punch positions.
Select Auto, and the machine automatically judges the staple or punch posi-
tions for the paper relative to the original direction loaded.
• A staple or punch position along the long side of the paper is selected if the
original length is 11-11/16 inches (297 mm) or less.
• A staple or punch position along the short side of the paper is selected if
the original length exceeds 11-11/16 inches (297 mm).
• Staple or punching positions are set on the upper or left-side end.
• Be sure to load the original so that its top side is placed in the back.
• If desired, press [Original Direction], and then select the original direction.
[Basic] 5.1
bizhub 652/552