Using An Authentication Unit (Biometric Type) - Konica Minolta Bizhub 652 User Manual

10.1

Using an authentication unit (biometric type)

10 Authentication unit (Biometric type)
This chapter describes the Authentication Unit (Biometric type).
1. Authentication Unit (biometric type) AU-101
2. Authentication Unit (biometric type) AU-102
10.1 Using an authentication unit (biometric type)
The Authentication Unit (biometric type) is a "biometrics (biometric authentication) system" that scans fin-
ger vein patterns to perform personal authentication. Using the biometric authentication, you can log in to
this machine where user authentication settings are configured in order to execute a print job.
Place your forefinger straight so that your forefinger cushion slightly touches the hollow and protuberance
part of the scanning section. Secure your middle finger and thumb on the both sides of the authentication
unit to prevent your forefinger to be used for authentication from rotating.
For details on how to place your finger on the authentication unit, refer to page 10-18.
NOTICE
If you change the authentication unit from the Authentication Unit AU-101 to Authentication Unit AU-102,
the users you registered with Authentication Unit AU-101 cannot use Authentication Unit AU-102. Con-
nect the Authentication Unit AU-102 to this machine, and then register the users again.
Do not place anything other than your finger on the scanning section during scanning operation. Doing so
may cause a malfunction.
Do not disconnect the USB cable from the authentication unit or computer during a scanning operation. Do-
ing so may cause the system to become unstable.
The status indicator LED and notice sound indicate the status of the authentication unit.
Status indicator LEDs
Lit in green
Flash in green
Lit in red
Unlit
bizhub 652/552
1
Status
Ready state or authentication is completed
During authentication or scanning operation
Authentication failed or scanning failed
The authentication unit is not recognized
2
10
10-3