Loading Paper Into Tray 3 And Tray 4; Loading Paper Into The Bypass Tray - Konica Minolta Bizhub 652 User Manual

8.1 Paper

Loading paper into Tray 3 and Tray 4

The procedure for loading paper is common between Tray 3 and Tray 4.
The following procedure describes how to load paper into Tray 3.
1
Pull out Tray 3.
NOTICE
Be careful not to touch the surface of the Paper Take-Up Roller
with your hand.
2
Lift up the Paper Take-Up Roller, and then load the paper into
the tray.
% Load the paper into the tray so that the side of the paper to be
printed on (the side facing up when the package was un-
wrapped) faces up.
% Do not load so many sheets of paper that the top of the stack
is higher than the , mark.
% Do not load the Tray 3 with paper of a size other than that pre-
viously specified.
% If paper is curled, flatten it before loading it.
% If special paper is loaded, the paper type must be specified.
% Load letterhead paper so that the side to be printed on faces down.
% To change the paper size for Tary 3, contact your service representative.
3
Lower the aper Take-Up Roller, and then close Tray 3.
d
Reference
To configure paper settings:
Press [Basic] ö [Paper].

Loading paper into the Bypass Tray

1
Open the Bypass Tray.
% To load large-sized paper, pull out the tray extension.
NOTICE
Be careful not to touch the surface of the Paper Take-Up Roller
with your hand.
2
With the side to be printed on facing down, insert the paper as far as possible into the feed slot.
% The image will be printed on the surface of the paper facing down when the paper is loaded into the
bypass tray.
% Do not load so many sheets of paper that the top of the stack is higher than the , mark.
% If paper is curled, flatten it before loading it.
% Push the Lateral Guide firmly up against the edges of the paper.
% Load letterhead paper so that the side to be printed on faces up.
bizhub 652/552
8
8-5