Konica Minolta Bizhub 652 User Manual page 79

5.1 [Basic]
Settings
[Offset] [Yes]/[No]
[Fold/Bind]
[Staple]
[Punch]
bizhub 652/552
Specify whether to separate each set of copies from another set in the output
tray when copying multiple sets of multi-page originals.
When the Finisher is not installed:
If the following conditions are met, printed copies are fed out and sorted in an
alternating crisscross pattern.
• The 8-1/2e11, A4, or B5 size paper is used
• Paper of the same size and type is loaded with the w orientation in one pa-
per tray and with the v orientation in another tray
• Auto paper selection is specified for the paper size setting
When the Finisher is installed:
The copies are fed out and stacked on top of each other with each set shifted
to separate it.
Staples copy outputs in the center the paper or fold them in the center before
discharging.
When the Saddle Stitcher SD-508 is installed in the Finisher FS-526:
[Half-Fold]
[Z-Fold]
To configure the Z folding setting, install the Z Folding Unit.
When the Saddle Stitcher SD-509 is installed in the Finisher FS-527:
[Half-Fold]
Staples copies in corner or at two points before they are output.
Punches holes in copies before they are output.
1
[Center Staple & Fold]
[Center Staple & Fold]
5
[Tri-Fold]
5-13