Chassis Installation And Rack Mounting - Planet GT-902 User Manual

2.2.2 Chassis Installation and Rack Mounting

To install the Managed Media Converter in a 10-inch or 19-inch with standard rack, follow the instructions described
below.
Step 1: Place your Managed Media Converter on a hard flat surface, with the front panel positioned towards your front
side.
Step 2: Carefully slide in the module until it is fully and firmly fitted into the slot of the chassis.
Step 3: Attach a rack-mount bracket to each side of the Chassis with supplied screws attached to the package.
Step 4: After the brackets are attached to the chassis, use suitable screws to securely attach the brackets to the rack, as
shown in Figure 2-6.
Step 5: Precede with the steps 4 and steps 5 of session 2.2.1 Stand-alone Installation to connect the network cabling
and supply power to your Chassis.
You must use the screws supplied with the mounting brackets. Damage caused to the parts by using
Caution:
incorrect screws would invalidate your warranty.
Figure 2-5: Insert a Managed Media Converter into an available slot
-10-