Chassis Installation And Rack Mounting - Planet FT-1105A User Manual

It
100Base-FX SFP on the converter. If you insert
a SFP transceiver that is not supported, the
Note
converter will not recognize it.
Step 4: Connect the fiber cable. Attach the duplex LC connector
on the network cable into the SFP transceiver.
Step 5: Attach fiber cable from the FT-1105A/FT-1205A to the
fiber network. TX, RX must be paired at both ends.
Step 6: Connect the 5VDC power adapter to the FT-1105A/FT-
1205A and verify that the Power LED lights up.
Step 7: Turn on the power of the device/station; the PWR LEDs
should light when all cables are attached.
Please refer to APPENDIX-A for detailed wiring
information of the FT-1105A/FT-1205A.
To prevent from optic acceptor malfunction, check
the both wires / transmitter before power on the
Note
converter.

6.2 Chassis Installation and Rack Mounting

To install the media converter in a 10-inch or 19-inch with
standard rack, follow the instructions described below.
Step 1: Place your FT-1105A/FT-1205A on a hard flat surface,
with the front panel positioned towards your front side.
recommends using PLANET MFB-FX series
15