Green Tube Connection; Red Tube Connection; Tank Ball Valve Installation; Yellow Tube Connection - Watts Premier HT-5-VOC-B Installation, Operation And Maintenance Manual

Green Tube Connection

Step 17
In the parts bag locate the 1/4" Green tubing. Connect the tube
to the RO system (left housing) by inserting it into the open 1/4"
quick connect fitting on the housing lid. Make sure the tube is
pushed in all the way to the tube stop.
Insert the other open end of the green 1/4" tube into the open 1/4" quick connect fitting on
Step 18
the plastic adapt-a-valve making sure the tube is pushed in all the way to the tube stop.

Red Tube Connection

Step 19 Locate the 1/4" x 1/4" union attached at the end of the red tube
coming out of the RO membrane housing. Insert the red tube from
RO faucet FIRMLY into the open end of the white plastic union. Use
a 5/8" wrench to tighten the white plastic nut securely.

Tank Ball Valve Installation

Thread the plastic ball valve onto the tank fitting. Do not apply Teflon tape to fitting.
Step 20
Do not over tighten or the valve could crack.

Yellow Tube Connection

Locate the 1/4" yellow tube in the parts bag. Insert one open end
Step 21
FIRMLY into the open tee fitting attached to the right side of the
final stage filter. Use a 5/8" wrench to tighten the white plastic
nut securely.
Position tank in desired location. Insert the open end of the yellow 1/4" tube from the RO System
Step 22
FIRMLY into the tank ball valve. Use a 5/8" wrench to tighten the white plastic nut securely.
Note: Set the ball valve knob in-line with the yellow tube, this is the "open" position.

Blue Tube Connection

Step 23 Locate the 1/4" blue tube attached to the RO faucet. Insert
the tube FIRMLY into the 1/4" open fitting on the left side of
the final stage filter. Use a 5/8" wrench to tighten the white
plastic nut securely.

Reverse Osmosis Module Mounting

Step 24 Determine best location for the RO module to be mounted to allow for future system
maintenance. Using the mounting holes on the bracket, mark the location for the mounting
screws on the cabinet wall under the sink. In the parts bag, locate the two self tapping screws.
Using an electric drill with a Phillips bit, screw them into the cabinet at the marked location.
Hang the module on the screws using the mounting holes in the bracket
This RO system is very heavy once filled with water.
Caution:
Use wall/cabinet studs when mounting to prevent damage to mounting surface.
Page 9
Green Tube
Adapt-a-Valve