Start Up Instructions - Watts Premier HT-5-VOC-B Installation, Operation And Maintenance Manual

Reverse osmosis system
Table of Contents

Advertisement

You have completed the installation of your new Reverse Osmosis system.

Start up Instructions

Warning: To prevent the possibility of electrical shock, clean up any water on
cabinet floor and dry all water from outside of RO unit.
Step 1
Turn on the cold water angle stop valve.
Turn the adapt-a-valve on and check the system for leaks and tighten fittings
as necessary.
Step 2
Plug the (24 volt) transformer
power cord connector into the
ESOV as pictured - ESOV is located
on the top-right side of RO system
on top of the system bracket.
Step 3
Plug the pump connector into the
ESOV as pictured.
Step 4
Plug the transformer into the
electrical outlet under the sink.
Step 5
Ensure ball valve on the storage
tank is open.
Step 6
Open the RO faucet and leave it
open until water begins to drip.
Then close the faucet.
The tank will take between 2 - 4
hours to fill.
Note:
Check daily over the next week
to ensure no leaks are present.
If booster pump does not turn on check the power outlet! It is possible that the
power outlet you used for the RO unit is controlled by the garbage disposal
switch. To test - Unplug the garbage disposal and flip the garbage disposal
switch to "on" . If the RO pump turns on, you will need to connect the system to
a different power outlet socket.
Step 7
After the tank has filled once, open the RO faucet and drain the tank.
Note:
Water may be cloudy or milky due to air in the system and carbon particles flushing out
of the final polishing filter. This condition will resolve itself after flushing a couple of
tanks of water.
Step 8
Complete step #7 two more times. The process of flushing the system first three times
should take about one day to complete. The fourth tank can be used for drinking water.
Note:
Flushing of the tank 3 times is only necessary during the initial startup and after replacing
the membrane.
Congratulations!
Please Follow the Startup Instructions.
Page 10
Transformer
TO Stage 2
Housing Lid
OUT
IN
FLOW
Booster
FROM Stage 1
Housing Lid
Pump
ESOV
"Power"
"Pump"

Advertisement

Table of Contents
loading

Table of Contents