GE Multilink ML3000 Instruction Manual page 313

CHAPTER 18: MISCELLANEOUS COMMANDS
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
• : sets the path cost of ports
cost
• : set the force version of STP
forceversion
•
help rstp
• : sets the RSTP administration status of ports
port
• : changes the priority of ports or bridge
priority
• : changes the RSTP administrative status of the bridge
rstp
•
show-forceversion
• : shows the port mode status
show-mode
• : shows the bridge time parameters
show-timers
• : changes the bridge time parameters
timers
The Simple Mail Transfer Protocol (SMTP) commands for e-mail are shown below. Refer to
E-mail on page 18–6 for additional details.
• : adds a recipient
add
• : deletes a recipient
delete
•
help smtp
• : sends e-mail
sendmail
• : sets the global SMTP server configuration
server
• : enables/disables SMTP e-mail alert
smtp
The Simple Network Management Protocol (SNMP) commands are shown below. Refer to
Configuring SNMP through the Command Line Interface on page 16–4 for additional details.
• : enable/disables the authentication traps
authentraps
• : configures SNMP community names
community
•
help snmp
• : adds or deletes the SNMP manager IP
mgrip
• : configures system name, contact, or location
setvar
• : adds or deletes a trap receiver
traps
The Simple Network Time Protocol (SNTP) commands are shown below. Refer to Network
Time on page 5–10 for additional details.
• : deletes the SNTP server from SNTP server database
delete
•
help sntp
• : adds SNTP server into the SNTP server database
setsntp
• : configures parameters for SNTP system
sntp
• : sets the interval for synchronization time with an NTP server
sync
The Spanning Tree Protocol (STP) commands are shown below. Refer to Spanning Tree
Protocol (STP) on page 12–1 for additional details.
•
cost
•
port
•
priority
•
stp
•
timers
The user commands are shown below. Refer to the User Management on page 1–15 for
additional details.
: shows the current force version of RSTP
MISCELLANEOUS COMMANDS
18–23