GE Multilink ML3000 Instruction Manual page 198

SPANNING TREE PROTOCOL (STP)
12–2
The table below lists the default values of the STP variables. Refer to the following section
for detailed explanation on the variables. By default, STP is disabled. To use STP, it has to be
manually enabled.
Table 12–1: STP default values
Variable or attribute
STP capabilities
Reconfiguring general operation priority
Bridge maximum age
Hello time
Forward delay
Reconfiguring per-port STP path cost
Priority
Mode
Monitoring of STP
Root Port
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
CHAPTER 12: SPANNING TREE PROTOCOL (STP)
Default value
Disabled
32768
20 seconds
2 seconds
15 seconds
0
32768
Normal
Not available
Not set