Logging In For The First Time; Automatic Ip Address Configuration - GE Multilink ML3000 Instruction Manual

INTRODUCTION
1.5.4

Logging In for the First Time

1.5.5

Automatic IP Address Configuration

Note
NOTE
1–12
The line interface prompt appears displaying the switch model number (e.g. ML3000>)
The switch has three modes of operation: operator (least privilege), manager, and
configuration. The prompts for the switches change as the switch changes modes from
operator to manager to configuration. The prompts are shown below with a brief
description.
• ML3000>
Operator Level - for running operations queries
• ML3000#
Manager Level - for setting and reviewing commands
• ML3000##
Configuration Level - for changing the switch parameter values
For additional information on default users, user levels and more, refer to User
Management on page 1–15.
For the first time, use the default user name and passwords assigned by GE. They are:
• Username: manager
Password: manager
• Username: operator
Password: operator
We recommend you login as manager for the first time to set up the IP address as well as
change user passwords or create new users.
The ML3000 is operational immediately after it is powered up. The advanced management
and configuration capabilities of the ML3000 allows you to easily configure, manage, and
secure your devices and network.
Before starting, ensure you have the following items:
• RJ45 Ethernet cable
• PC with an Ethernet port
• Microsoft Internet Explorer 6.0 or higher
• Macromedia Flash Player 5.0 or higher (available from
www.macromedia.com/shockwave/download/
download.cgi?P1_Prod_Version=ShockwaveFlash)
Ensure both firmware components are installed before proceeding.
The ML3000 can search the network for commonly used services that can issue an IP
address. If the switch is connected to a network, the ML3000 uses the following process to
find an IP address.
If the ML3000 is not connected to a network, then proceed to Step 3 below. or use the
default IP address.
Step 1:
The ML3000 will scan the network for a DHCP server. If the server responds, the ML3000
will acquire and set the assigned IP address. To manage the switch, determine the
assigned IP address and enter as follows in Internet Explorer:
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
CHAPTER 1: INTRODUCTION
http://