GE Multilink ML3000 Instruction Manual page 312

MISCELLANEOUS COMMANDS
18–22
•
set-qri
• : enables or disables switch as querier
set-querier
• : displays IGMP group list
show-group
• : displays IGMP port mode
show-port
• : displays IGMP router list
show-router
The Link Aggregation Control Protocol (LACP) commands are shown below.
•
lacp
•
add port
•
del port
•
edit port
The port mirroring commands are shown below. Refer to Port Mirroring on page 9–1 for
additional details.
•
help port-mirror
• : enables/disables port mirroring functionality
prtmr
• : defines the port mirroring ports
setport
The port security commands are shown below. Refer to Securing Access on page 6–1 for
additional details.
• : sets the action type of secured port
action
• : allows MAC addressing per port
allow
•
help port-security
• : enables/disables security for a single port or group of ports
learn
• : enables/disables security in system
ps
• : removes MAC addressing per port
remove
• : sets the signal type of the secured port
signal
The quality of service (QoS) commands are shown below. Refer to Commands on page 14–
4 for additional details.
•
map
•
setpoint
•
help qos
• : configures QOS configuration usage
setqos
•
set-untag
• : sets the port priority weights for all the ports in all the device
set-weight
•
show-portweight
The remote monitoring (RMON) commands are shown below. Refer to Configuring RMON
on page 16–15 for additional details.
• : sets the owner for the alarm group
alarm
• : sets the owner for the event group
event
•
help rmon
• : sets the owner for the history group
history
• : sets the owner for the statistics group
statistics
The Rapid Spanning Tree Protocol (RSTP) commands are shown below. Refer to Configuring
RSTP through the Command Line Interface on page 13–4 for additional details.
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
CHAPTER 18: MISCELLANEOUS COMMANDS
: displays the current port weight priority