SMART for two coupé Operator's Manual page 195

You may operate the electrical air pump
again after it has cooled off.
If a tire inflation pressure of at least
X
200 kpa (2.0 bar, 29 psi) is not attained,
turn off the electric air pump by press-
ing OFF on electric air pump switch ?.
Unscrew the end of filler hose ? from
X
tire valve C.
After clearing the area around the vehi-
X
cle of people and obstacles, drive vehi-
cle back or forth very slowly approx-
imately 30 ft (10 m).
This serves to better distribute the tire
sealant material inside the tire.
Screw the end of filler hose ? onto tire
X
valve C.
Inflate the tire again.
X
G WARNING
If a tire inflation pressure of
200 kPa (2.0 bar, 29 psi) is not attained, the
tire is too severely damaged for the tire
sealant to provide a reliable tire repair.
In this case, the tire sealant cannot prop-
erly seal the tire.
Do not drive the vehicle.
Contact the nearest authorized electric
drive smart center for assistance or call
Roadside Assistance.
After attaining a tire inflation pressure
X
of at least 200 kPa (2.0 bar, 29 psi), press
OFF on electric air pump switch ?.
The electric air pump is switched off.
Turn the key in the starter switch to
X
position 0.
Unscrew the end of filler hose ? from
X
tire valve C.
Place the tire repair kit securely in the
X
vehicle.
Drive off immediately.
X
The tire sealant will distribute itself
evenly inside the tire.
G WARNING
Do not exceed vehicle speed of 50 mph
(80 km/h). A tire sealant repair is not
designed to operate at higher speeds.
The sticker must be attached on the instru-
ment cluster where it will be easily seen by
the driver.
Vehicle handling characteristics of a tire
sealant repaired tire may change. Adapt
your driving accordingly.
After driving for about 1.8 miles (3 km)
X
or ten minutes, stop and exit the vehicle
taking all of the appropriate safety pre-
cautions.
Take the tire repair kit from the vehicle.
X
Screw the end of filler hose ? onto tire
X
valve C.
Check the tire inflation pressure using
X
pressure gauge E.
G WARNING
If tire inflation pressure has fallen below
130 kPa (1.3 bar, 19 psi) do not continue to
drive the vehicle.
Park your vehicle safely away from the
roadway and contact the nearest authorized
electric drive smart center or call Road-
side Assistance.
Have the damaged tire replaced.
If the tire inflation pressure is at least
X
130 kPa (1.3 bar, 19 psi), inflate or deflate
the tire to correct tire inflation pres-
sure (see Tire and Loading Information
Flat tire
193
Z